 Notes:
This tut was done in PSP 10 but should work as well in other versions. Some knowledge of, and experience with, PSP is required. A trial version of PSP can be downloaded from here. You are welcome to use my images, or use your own If any filters are used, please note that if you don't already have them installed that you will have to close PSP, Install, then start PSP again. Advanced Supplies:
Balance_Wolfmorphine_MistedByGinni_05-21(2)
2_Mask
2vuzf2s
Preparation: Pick 2 Colors from your image
Open a 350 x 350 transparent image
Take your tube
Re-size to 50%
(175 x 175)
Edit/Copy
Edit/Paste as a new image 2x
Close the original
Take 1 of the tube images
Image/Greyscale
Leave the other 1 alone
Step 1:
Take your 350 x 350 image
Flood Fill with your dark color
Layers/New Raster Layer
Flood fill with your other color
Layers/Load-Save Mask/Load Mask From Disk/2_Mask  Layers/Merge/Merge Group
Layers/Merge/Merge Visible
Layers/New Raster Layer
Flood Fill with White
Lower the opacity to 30
Layers/Load-Save Mask/Load Mask From Disk/2vuzf2s  Lower the Opacity to 30
Layers/Merge/Merge Group
Layers/Merge/Merge Visible
Step 2:
Take the colored image of the tube Edit/Copy
Edit/Paste as a new Layer
Move to the lower left side
Effects/3D Effects/Drop Shadow  Step 3:
Take the image of the tube that is greyed out
Place this image in the upper right hand corner
Lower the opacity to 20%
Effects/3D Effects/Drop Shadow
Layers/Merge/Merge Visible Step 4:
Selections/Select All
Effects/3D Effects/Buttonize  Layers/New Raster Layer
Add Watermark
Add Name
Add Caption
Layers/Merge/Merge Visible
2009-2011 6-17-10   |
|
Make a Free Website with Yola.
